Thanks to the timely advice from Thukydides - it was not too late to add a curve to the counter.
Transferring the shape of the curve from the fashion piece (yes, the curve is too high, we caught it in time and were not sanding up to the line)
Continuing with a habit of never sanding freehanded, using various blocks instead 😊
Sanding 8 plywood layers at once is surprisingly hard and takes forever, I guess the pressure is too distributed across them, and sandpaper does not get a proper bite.
It was another exercise in keeping a constant angle and not wiggling your hand. The skill of keeping a constant angle is one of the hardest for a child, apparently.
The result is quite neat, that curve is much more pleasant!
Keel glued in, now cleaning up the laser char with a handplane (to avoid smearing it into the wood with sandpaper). She loves the miniature Veritas planes, they fit into a small hand even better than into an adult one ☺️
Even the curve was, eventually, planed. Except the end of it where you plane the cross grain.
The very end grain was sanded, and again she was struggling to keep the 90deg angle.
Then we decided to add a chamfer using a plane, and to aid with the dreaded angle holding I was holding a template, which did help a lot!
Resulting chamfer was something to be proud of, very consistent!
The stem itself got similar chamfers, though I did a bit of touch up here. Chamfering cross and diagonal grain is too tricky for a beginner.
One of the surprises of the kit is the entire keel / stem assembly is cut of two pieces, making the front tip of the stem 100% cross grain. I really hope it would not crack it while building, an unsupported crossgrain piece on the most visible part of the hull.
Guess this is what Chris was hinting on when he said it was a pretty old kit design, and he would have done it differently nowadays with all the new experience 😊
But this cutout for a rabbet is a very neat addition, haven't seen it before. Makes fixing the top edge of the plank so much easier!
Now the planking can begin!
Measuring an offset from the top of the bulkhead using a miniature marking gauge from Veritas. Circular "knife" is a bit unusual to work with, but she got the hang of it and made pretty consistent marks.
What a time to be a kid! So many amazing tools that are a pleasure to use, hope this factor would help her to get deeper into crafts, hopefully wood-adjacent.
Tried to use pins to hold the planks, but my pins were too large and cracked the bulkhead. The kit-supplied are much smaller, but hence more fiddly to use 😅
Luckily the top row can be clamped without any pins:
The strips supplied in the kit are quite well selected - perfect thickness and hardness, can be bent without soaking, but are not floppy noodles.
They keep shape pretty well, I do not see any "dips", and the edge is sharp. Very happy with them! And this is for the "first planking" which some other manufacturers are cheaping out on.
Fist plank is on the hull! Now we just need to get into a habit of installing a couple per week, at least. See you next year, I guess? 😁
By
Mike Y ·